Will this new wall hold/retain ?

Discussion in 'Development' started by LifesGood, 7th Apr, 2017.

Join Australia's most dynamic and respected property investment community
  1. LifesGood

    LifesGood Well-Known Member

    Joined:
    26th Jun, 2015
    Posts:
    911
    Location:
    Perth WA
    Hi All!

    As part of my current development, retain and build at rear, I am currently doing works to the front property. I've had a courtyard wall built to separate the new car bay locations from the new front courtyard area.The land is slightly sloping left to right, but my earth worker has done a good job at separating the levels for me.

    Here is my concern. The left courtyard area is now a fair bit higher than the right hand side parking area and as such, I am concerned that this new wall will not be sufficient to retain the new concrete path that will be running along it on the courtyard side.

    I've attached my own little sketch and some images. I'm not after an engineer's certification here, just some opinions! :) thanks in advance for your feedback!
     

    Attached Files:

  2. Paul@PAS

    Paul@PAS Tax, Accounting + SMSF + All things Property Tax Business Plus Member

    Joined:
    18th Jun, 2015
    Posts:
    23,536
    Location:
    Sydney
    Are you asking as you are concerned its not stable ? Doesnt that address the question ?

    When I have done earthworks on land I have found council guidance helps. In one property they required engineering certs for a cut of 500m or a fill of 500mm or any combination. Basic retaining walls were approved between the cut and fill no drama. Mine was 400mm in some parts and 600mm in others so it wasnt worth ignoring.
     
  3. vbplease

    vbplease Well-Known Member

    Joined:
    18th Jun, 2015
    Posts:
    1,575
    Location:
    Brisbane
    As per your sketch the difference in height will only be one brick course? Should be fine.
     
  4. Wooden

    Wooden Active Member

    Joined:
    13th Aug, 2015
    Posts:
    34
    Location:
    Perth
    While I wouldn't recommend going any higher I'd suggest that the 70mm between the base of the upper slab and top of the lower slab should be fine.

    It's unlikely any serious loading will occur within 100mm of the wall to apply load to it.
     
  5. Stoffo

    Stoffo Well-Known Member

    Joined:
    14th Jul, 2016
    Posts:
    5,331
    Location:
    In the Tweed
    By the last sketch
    772mm of concrete should support a Titanic weighted car :eek:
    (Glad i am not paying for all that concrete)

    For the record, retaining wall under a meter, with a proper footing and wall tied back into the slab with a decent compacted fill medium underneath, shouldnt be a problem ;)
     
  6. Westminster

    Westminster Tigress at Tiger Developments Business Member

    Joined:
    3rd Jun, 2015
    Posts:
    11,357
    Location:
    Perth
    I think that would be fine and could retain 300mm
     
  7. LifesGood

    LifesGood Well-Known Member

    Joined:
    26th Jun, 2015
    Posts:
    911
    Location:
    Perth WA
    haha the sketch is actually to scale, the 772mm is the height of the brick wall :)
     
    Stoffo likes this.
  8. JDP1

    JDP1 Well-Known Member

    Joined:
    19th Jun, 2015
    Posts:
    4,244
    Location:
    Brisbane
    Dunno.. I think trumps wall on the Mexican border will hold.
     
  9. Paul@PAS

    Paul@PAS Tax, Accounting + SMSF + All things Property Tax Business Plus Member

    Joined:
    18th Jun, 2015
    Posts:
    23,536
    Location:
    Sydney
    Chinese say they have a bigger one
     
  10. LifesGood

    LifesGood Well-Known Member

    Joined:
    26th Jun, 2015
    Posts:
    911
    Location:
    Perth WA
    and cheaper
     
  11. Westminster

    Westminster Tigress at Tiger Developments Business Member

    Joined:
    3rd Jun, 2015
    Posts:
    11,357
    Location:
    Perth
    Is there any rebar from footings through the single leaf wall?
     
  12. LifesGood

    LifesGood Well-Known Member

    Joined:
    26th Jun, 2015
    Posts:
    911
    Location:
    Perth WA
    Nope, only in the brick piers have a steel rod in the centre. Single leaf wall is tied into piers with two brick ties.